• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
g.   Operate the WINCH CABLE
E.  LOOSENESS CHECK.

TM-1-1520-240-MTF Army Model CH-47D Heilcopter (EIC:RCD) Manual
Page Navigation
  98    99    100    101    102  103  104    105    106    107    108  
TM 1-1520-240-MTF 4-10 CAUTION In case of an in-limit switch failure, do not al- low the end of the cable to reel in and jam in the reel assembly. The winch may be damaged. k.   Operate the winch to reel in the remaining length  of  the  cable.  Check  that  the  cargo mode in-limit switch stops the winch when 3 feet  of  the  cable  remain  extended.  If  the winch  does  not  stop  when  the  specified length of cable is extended, adjust the cargo mode  in-limit  switch  or  have  it  replaced. (Refer to TM 55-1520-240-23.) l.   Place the shifting lever to RESCUE. Unplug the     cable     cutter     from     the     stowage receptacle and connect it to the overhead receptacle above the rescue hatch. NOTE RESCUE operation mode is used to reduce reel- out time. Keep tension on the cable while it is reel- ing out. m.   Operate  the  winch  to  reel  out  the  cable. Continue to operate the winch until the cable is fully extended. n.   Set the shifting lever to CARGO. Unplug the cable cutter from the overhead receptacle and connect it to the stowage receptacle. o.   Attach a 3,100 to 3,300-pound load to the winch cable.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.