TM 1-1520-240-BD
Figure 9-14. Item B13 Shielded Cable Repair
NOTE
The item number on each illustration
indicates the location of the repair
material storage container and/or
required tools within the wiring
repair kit portion of the ACMI/BDR
wiring repair set.
(3)
Shield Terminators. The repair set
provides capability for terminating cable shields of
various diameters and temperature ratings. The shield
terminator techniques for the three different diameter
terminators are shown in Figures 9-15, 9-16, and 9-17.
When selecting a shield terminator for shielded wires,
select the smallest terminator that slides easily over the
prepared cable. For 125°C, only the folded back, end-
strip method is authorized.
NOTE
The item number of each illustration
indicates the location of the repair
material storage container and/or
required tools within the wiring
repair kit portion of the repair set.
(4)
Terminal Lugs and Terminal Boards. The
repair set provides capability for repairing terminal lugs
of stud sizes 6, 8, 10, and 1/4 inch wires of 22 thru 14
AWG and of stud sizes 4, 6, 8, and 10 for 24 AWG
wires. The set also provides terminal boards and
hardware for number 8 studs. Figure 9-19 provides
instructions for terminal board replacement. Figure 9-20
provides the instructions and selection table for terminal
lug repair.
9-15
