TM 55-1520-240-T4-7.3ENGINE ACCESSORY GEARBOX CHIP DETECTORS4-7.3OPERATIONAL CHECK (Continued)TASKRESULT1.Check that HYDRAULICS MAINT PNLIf circuit breaker (1) is open, close it. If it openscircuit breaker (1)is closed.again, go to task 8-14.3.2.Check master caution panel (2).If NO. 1 or NO. 2 ENG CHIP DET capsule (3 or 4)is lit, go to task 4-7.4.3.Check NO. 1 and NO. 2 ENGINE CHIPBoth indicators shall be all-black. If either in-DETECTOR indicators (5 and 6).dicator displays black-and-white fan, go to task 4-7.5.4.Set and hold GND switch (7) to TEST. NO. 1 and NO. 2 ENG CHIP DET capsules (3 and4) shall come on. NO. 1 and NO. 2 ENGINE CHIPDETECTOR indicators (5 and 6) shall change toblack-and-white fan. If NO. 1 ENG CHIP DETcapsule is out, go to task 4-7.6. If NO. 2 ENGCHIP DET capsule is out, go to task 4-7.7. If NO. 1or NO. 2 ENGINE CHIP DETECTOR indicator isall-black, go to task 4-7.8.5.Set GND switch (7) to RESET, then toNO. 1 and NO. 2 ENGINE CHIP DETECTOR in-GND.dicators (5 and 6) shall change to all-black. Ifboth indicator displays are not black, go to task 4-7.5.CHECK NO. 1 ENGINE ACCESSORYGEARBOX CHIP DETECTOR6.Short terminal stud of NO. 1 engine chipNO. 1 ENG CHIP DET capsule (3) shall come ondetector (8) to its mounting base with aand NO. 1 ENGINE CHIP DETECTOR indicatorjumper wire.(5) shall change to black-and-white fan. If capsuledoes not come on and indicator display doesnot change, go to task 4-7.9.7.Remove jumper. NO. 1 ENG CHIP DET capsule (3) shall go out. If itstays on, go to task 4-7.4.8.Set GND switch (7) to RESET, then toNO. 1 ENGINE CHIP DETECTOR indicator (5)GND.display shall change to all-black. If it does not, goto task 4-7.5.CHECK NO. 2 ENGINE ACCESSORYGEARBOX CHIP DETECTOR9.Short terminal stud of No. 2 engine chipNO. 2 ENG CHIP DET capsule (4) shall come ondetector (8) to its mounting base with aand NO. 2 ENGINE CHIP DETECTOR indicatorjumper wire.(6) shall change to black-and-white fan. If capsuledoes not come and indicator display does notchange, go to task 4-7.9.10. Remove jumper. NO. 2 ENG CHIP DET capsule (4) shall go out. If itstays on, go to task 4-7.4.TASKRESULT11. Set GND switch (7) to RESET then toNO. 2 ENGINE CHIP DETECTOR indicator (6)GND.display shall change to all-black. If it does not, goto task 4-7.5.FOLLOW-ON MAINTENANCE:TM 55-1520-240-23:Remove electrical power.Disconnect battery.Close No. 1 or No. 2 engine work platformand access door.END OF TASK4-181
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business