TM 1-1520-240-CL
P-9
8. Restore the M-1 switch to ON.
9. Repeat (7) and (8) above for the M-2, M-3/A and
M-C mode switches.
10. Place the ANT switch TOP.
11. Repeat (7), (8), and (9) above.
12. Place the ANT switch DIV.
13. Repeat (7), (8), and (9) above.
NOTE
If KIT1C is not installed or keyed the following
steps are not required.
14. Set the MODE 4 rotary switch to A. If the
external computer is used, set a code in it.
15. Set the MODE 4 AUDIO/LIGHT/OUT switch to
OUT.
16. Hold the MODE 4 TEST/ON/OUT switch to
TEST.
17. If the computer is used, observe that the TEST
GO indicator lights. If the computer is not
connected, observe that the TEST/MON/NO
GO indicator lights and the KIT STATUS
indicator lights.
18. Observe that the MODE 4 REPLY light and
CAUTION light (on a separate “panel”) do not
light.
19. Restore the MODE 4 TEST/ON/OUT switch to
ON for computer use, or to OUT if no computer
is used.
