TM 1-1520-240-MTF
2-74
*B BEFORE TAKEOFF (CONT.)
6. Transponder — As required.
7. Crew and mission equipment — Check.
CRUISE
1-20.
1. AFCS Control Panel — As required.
NOTE
Operating the maintenance panel test switch in
flight will cause the caution panel lights to go on.
The flight engineer shall alert the pilot when the
test switch is used in flight.
BF 2. Ramp area and maintenance panel — Check
every 30 minutes.
3. Fuel consumption — Check.
IN-FLIGHT
1-21.
1. Speed Sweep — Check.
CAUTION
With inoperative CGI, do not exceed airspeed
limits (figure FO-1).
NOTE
FWD and AFT LCT schedules corrected for
increases in pressure altitude are shown in
Section V.
a. Stabilize airspeed at 50 knots. Observe both
CYCLIC TRIM indicators are in the 60 knot
(RET) range.
