TM 1-1520-240-MTF
2-59
ENGINE RUN UP (CONT.)
f. Repeat steps a. through e. for NO. 2 ENG.
B 10. 714A Reversionary System Check (first flight
of day) may be omitted if performing FADEC
Reversionary mode beep check.
a. FADEC 1 switch — REV.
b. No. 1 INC/DEC switch — DEC momentarily.
Check #1 ENG, N1 and TRQ decreases.
c. No. 1 INC/DEC switch — INC momentarily.
Check #1 ENG, N1 and TRQ increases.
d. FADEC 1 switch — PRI.
e. Repeat steps a thru d. for No. 2 FADEC.
f. Set RRPM to 100%, TQs matched, set
FADEC 1 & 2 switches to PRI.
11. Systems
instruments
—
Check
engine,
transmission,
rotor,
and
fuel
systems
indications. 712 Master Caution panel, 714A
Master Caution/Advisory panel — Check
B 12. Altimeters — Set/Test.
a. Barometric altimeter — Recheck tower
setting.
b. Radar Altimeter —Check (Refer to Section
IV).
B 13. Transponder — Check and Set.
BO 14. AN/ASN-128 Doppler — Program doppler with
UTM (or latitude/longitude) coordinates for
checkpoints in test course. Enter magnetic
variation.
BO 15. AN/ASN-128B DGNS.
a. Load several known local waypoints into
DGNS either through CDU or through Data
Loader Module.
