TM 55-6930-212-10
k.
Depress FREEZE switchlight. Start flying demo. Recording process has started. Cockpit controls and instructor
interactions are being recorded for future playback.
l.
At planned maneuver points, depress MANEUV MARK switchlight on instructor/pilot control panel. Up to nine
maneuver marks can be inserted.
m.
Depress FREEZE switchlight to halt recording.
n.
Depress thumbwheel DELETE switchlight. DEMO RECORD light extinguishes. Recording process is
terminated. Demo just recorded has been saved on disk.
8-34. CORRECTING THE DEMONSTRATION FLIGHT.
8-35. The recorded demo can be rerecorded to correct errors or add additional material. The rerecording process can
start either at the beginning of the demo or at any maneuver mark. In either case, the remainder of the demo must be
rerecorded in order to retain demo continuity. If the demo is to be rerecorded from the start, follow the steps outlined in
paragraph 8-33. If rerecording from a maneuver mark, proceed as follows:
a.
Initialize simulator to starting maneuver mark point:
(1)
Set IOS thumbwheels to maneuver number.
(2)
Depress thumbwheel INSERT switchlight.
NOTE
The first two thumbwheel digits represent the demo number and the third digit the maneuver
number. For example, a selection of 100 would represent start of demo, 101 first maneuver
mark, and 109 ninth or last maneuver mark.
NOTE
While the simulator is initializing, the freeze lamp blinks and goes steady when initialization is
complete.
(3)
Depress thumbwheel DELETE switchlight.
b.
Set up cockpit and IOS to desired configuration.
c.
Switch record mode:
(1)
Depress DEMO RECORD switchlight.
(2)
Depress thumbwheel INSERT switchlight. FREEZE lamps flash while setting up for recording and then
stop with PROCEED WITH DEMO RECORD message displayed. Remainder of demo from maneuver
mark on has been deleted and must be rerecorded.
d.
Make a last check and prepare to fly simulator.
8-29
